McLaughlin MCL 36C, Руководство по ремонту

Страница: 57 / 90

SERVICE AND MAINTENANCE
6.1 Lubrication System
6.1.1 Oil Change Intervals
The oil change intervals are
dependent on the engine application
and the quality of the lube oil.
If the engine runs fewer hours during
the year than stated in the table, the
oil should be changed at least once
a year.
The table refers to the following
conditions:
- For diesel fuel: sulphur content max.
0.5% by weight.
- Continuous ambient temperatures
down to -10°C (+14°F)
If the sulphur content is > 0.5 to 1% or
the continuous ambient temperature
below -10°C (+14°F), the intervals
between oil changes should be
halved.
In case of fuels containing more than
1% sulphur, contact your service
representative.
6.1.2 Checking Oil/
Checking Engine Oil
6.1.2.1 Checking Oil Level 6.1.2.2 Engine Oil Change
Gensets as referred to here are units operating in
parallel with the main / with each other. Emergency
power units are dealt with in TC 0199-99-1126.
Check the oil level with the engine
turned off.
Allow the engine to warm up.
Check the oil level, and if necessary,
top up to the “MAX” mark. If the oil
level is only just above the “MIN”
mark, more oil must be added.
Wipe the dipstick with a non-fibrous,
clean cloth.
Remove the oil dipstick
Ensure that the engine or vehicle is in
a level postition.
Insert it to the top and remove again.
The oil level must not fall below the “MIN”
marking.
Ensure that the engine or vehicle is
on a level postition.
Turn the engine off.
Place oil tray under the engine.
Unscrew drain plug.
Fit oil drain plug, with the
new gasket and tighten firmly
(for torque, see 9.2)
Pour in lube oil.
- For grade/viscosity, see 4.1
- For quantity, see 9.1
Drain oil.
Check oil level, see 6.1.2.1
Be careful when draining hot oil -
danger of scalds! Do not let used
oil run into the soil but catch it in
a container ready for proper
disposal.
5.1.21