McLaughlin MCL 36C, Руководство по ремонту

Страница: 85 / 90

5.6.2
10. Remove the clutch spacer.
11. Remove the clutch by pulling if off the end of the input shaft
of the transmission. Lay the clutch on a solid surface
facing upward.
IF TOTALLY REPLACING THE CLUTCH REFER TO NO. 33
Step 3: Clutch Disassembly
Refer to the following steps for clutch disassembly.
Steps 12-14 Disk Kit Replacement
Steps 12-17 Seal Kit Replacement
Steps 12-19 Bearing Kit Replacement
12. Remove and discard the snap ring holding the disks
together. (NOTE: THE DISKS ARE UNDER PRESSURE.
THE DISKS MUST BE COMPRESSED BEFORE THE
SNAP RING CAN BE REMOVED. EYE PROTECTION
MUST BE WORN FOR SAFETY).
13. Once the snap ring is off, remove the front plate. Remove
and discard the following: six (6) belleville springs, five (5)
separator disks, and six (6) friction disks. (DO NOT
DISCARD THE FRONT PLATE OR PRESSURE PLATE).
14. Clean the front plate and pressure plate if necessary.
(MAKE SURE THAT BOTH PLATES ARE COMPLETELY
DRY BEFORE REASSEMBLING).
15. Support cylinder assembly, on bearing side, and push
down on hub. Remove and discard snap ring. (EYE
PROTECTION MUST BE WORN FOR SAFETY).
16. Support clutch on pressure plate. Push down on hub to
remove from cylinder assembly.
17. Use low air pressure to separate cylinder assembly from
piston assembly and pressure plate. Remove and
discard o-rings. At this point, inspect bearing for wear. If
bearings are acceptable, refer to step 23.
18. Remove the two (2) bearing removal plugs in cylinder
face. Use two (2) 1/4” diameter rods to tap bearing out of
cylinder counterbore. (NOTE: DO NOT STRIKE THE
COUNTERBORE WITH THE RODS).
19. Remove the two (2) bearing removal plugs in piston face.
Use two (2) 1/4” diameter rods to tap bearing out of piston
counterbore. (NOTE: DO NOT STRIKE THE
COUNTERBORE WITH THE RODS).
11
12
16
17
18