McLaughlin MCL 36C, Руководство по ремонту

Страница: 88 / 90

ASSEMBLY
Step 5: Installing the hydraulic clutch fitting. (These instruc
tions are for use only if the fitting is being changed or
replaced.)
33. Remove the hydraulic clutch fitting from the old clutch.
34. Clean off any remaining sealant from the fitting.
35. Apply a drop of removable thread sealant to the pipe
thread of the fitting. (NOTE: THE FITTING MUST BE
CLEAN AND DRY BEFORE ANY SEALANT CAN BE
APPLIED).
36. Install the fitting with the sealant into the clutch and
tighten. (NOTE: THE FITTING MUST BE FACING THE
SAME DIRECTION AS IT WAS BEFORE IT WAS RE
MOVED).
Step 6: Installing the clutch
37. Replace the clutch on the input shaft of the transmission.
Slide the clutch spacer over the input shaft until it bottoms
against the spline. (NOTE: BE SURE THE CLUTCH
FITTING IS PROPERLY IN THE CLUTCH RESTRAINT
CLIP).
38. Wrap the hydraulic clutch hose around the inside of the
bell housing so it reaches the clutch fitting. Tighten the
hose making sure it is securely inside the bell housing.
(THE HOSE MUST NOT EXTEND PAST THE FRONT
PLANE OF THE BELL HOUSING).
39. Replace the nylon strap between the oil drain plug and the
transmission spacer plate.
40. Move the transmission back into the machine carriage.
(BE CAREFUL NOT TO DAMAGE HYDRAULIC LINES AND
MACHINE COMPONENTS STILL IN PLACE).
REPAIR INSTRUCTIONS
McL 36/42C
36
38
5.6.5