PBXgateway II Quick Installation Guide
30
Connecting to the EXTender 6000 - RVP_IP
This page provides the necessary information to configure the PBXgateway II for connection to an
EXTender 6000 over a managed IP network.
Prerequisites for Configuration
•
The PBXgateway II (at the corporate site) and the EXTender 6000 (at the branch office) must be
installed properly and the network link between both devices must be operational.
•
The network administrator must assign IP address information for both PBXgateway II and EXTender
6000 units.
•
The network administrator must provide the remote users with User ID’s and Connect Passwords (if
assigned).
Configuration Items
The following parameters need to be configured on the PBXgateway II. Refer to the PBXgateway II
System Administrator’s Guide for complete set up information.
You must…
To…..
Default Settings
Set the phone port
compression algorithm for
all active phone ports.
Provide adequate band- width for all
users.
ADPCM 32
(on all phone ports)
Disable both WAN Ports
Disable WAN ports that are unnecessary
for RVP_IP
WAN 1 – Enabled
WAN 2 - Disabled
Tune Jitter Delay and
Packet size
Tune voice parameters to match IP
network characteristics.
Jitter Delay: 50
Packet Size:2
Set IP parameters
including:
IP Address
Subnet
Default Router
Identify the PBXgateway II over the IP
network.
-
* We recommend setting the Jitter Delay to 20, and the Packet Size to 4.
