EXTender 6000 Quick Installation Guide
7
Prerequisites for Installation
You must meet the following requirements before installing the EXTender 6000:
Network Requirements
•
You must install and configure appropriate network terminating devices at both the corporate facility
and the branch office. Both network-terminating devices must be fully functional and both must
support an RS-232, V.35, or RS-530 synchronous, asynchronous or Voice over IP (VOIP) interface.
•
If you use an asynchronous connection, you must install the appropriate ISDN Terminal Adapters
(TAs), from the list below. The TAs must be operational at both the corporate facility and the Branch
Office. This list is complete as of the release date of this document. Refer to the MCK’s Web site:
http://www.mck.com/
for the most recent list of recommended ISDN TAs. If using a synchronous
connection please see page 19 for more information.
Table 1:
ISDN TAs
Manufacturer
Model
3Com 3Com
U.S.
Robotics
Adtran ISU
2X64
ISU 128
Express NTU
Express 3000
Motorola
Bitsurfr Pro (rev 1M)
Bitsurfr Pro EZ
Bitsurfr Pro for Europe
-- <MANUAL_SETUP_1>
<MANUAL_SETUP_2>
* Connect
IQ 400 Series
* Multitech
IWAY Hopper (Async only)
* European Use
Note: For the Async-RS 232 Dial feature to work properly for these devices, you must set up each device
to accept incoming “AT Commands”. Consult the documentation provided with each device for
proper instructions.
Provide proper wiring with adequate punchdown blocks to connect the Remote Unit to the telephones.
Follow the details in Pin Out Assignments on page 14, and provide an RJ-21 female connector.
