EXTender 6000 Quick Installation Guide
21
WAN Port Set up
The EXTender has two WAN ports (WAN 1 and WAN 2). The ports communicate via an RS-232,
RS-530 or V.35 interface and provide the connections to the third party network devices.
Settings
The following settings are available to the system administrator to manage
these WAN ports:
•
Enabling/Disabling WAN port
s- Individually Enable or Disable a specific
WAN port (below)
•
Setting the Sync Rate
– Sets the specific WAN port to the sync rate (syn-
chronous serial port transfer speed) of the network device (CSU/DSU).
(refer to page 22)
•
Setting the Interface Mod
e- Choose the interface signaling type used to
communicate with the network device. (refer to page 23)
Procedure
1. Access
the
WAN 1
or
WAN 2 Menu
using the following path;
Path
: Gateway->Configuration->WAN 1 or
2
The following menu appears.
Figure 9:
WAN Menu
2. Press
the
Æ
key to access the
Enabled
parameter.
3. Press
the
Æ
key to change the availability of the port to: Enabled (Yes ) or Enabled (No).
4. Press
the
Å
key to accept changes and go back to the Configuration Menu.
5. Press
the
È
key to the Save parameter.
6. Press
Enter
to save changes to the active config (.
re
m) file.
