EXTender 6000 Quick Installation Guide
32
Placing a Call
What to verify before placing a call:
•
The Gateway recognizes ports on the PBX and the EXTender recognizes telephones. The MI should
display “RD” (Ready).
•
The Terminal device is properly configured to meet the requirements of the install.
Examples:
CSU/DSU:
DSO channels mapped properly, timing and framing setup correctly and configured to the
protocol (V.35).
TA:
Signal to the BRI circuits displays the correct SPID. DN numbers have been programmed.
Using the digital telephones connected to the PBX
Once the EXTender is installed and powered-up, go on-line with the telephones at the Branch Office
location. Follow the procedure below to place a call.
Procedure
At the Branch Office location, the telephones should display the following message:
Press “1” to connect
Press
1
on the keypad to connect the telephone to the corporate PBX.
Place a test call and check for clear reception.
Note: If the connection is “noisy” or non-existent, refer to the System Administrator’s Guide for trouble-
shooting steps.
Using the analog line connected to the EXTender
Note: This procedure applies only to the single analog telephone line connected to the EXTender and
only digital telephones can utilize this feature. You must install and wire the EXTender according to the
procedures on page 13 of this document. The analog line card is not available outside North America.
Procedure
1. Pick up the handset and press the
Analog Call Key
(
Meridian, Panasonic and Magix
- Default is Key 12
Iwatsu
- Default is Key 4
Note: This key bypasses the PBX/ADIX at the corporate facility and provides you with a telephone
line for dialing local and emergency (911) calls. Contact the systems administrator for the appropriate
key.
2. Dial the number.
