EXTender 6000 Quick Installation Guide
27
2. Press
the
Æ
key to access the parameters
3. Press
the
Æ
key to the
DCE Type
parameter. Press the
Æ
key to select the ISDN TA being used.
(See page 7
for a list of recommended devices.)
4. Press
the
È
key to the
Async Rate
parameter. Press the
Æ
key to select the rate required. This
parameter sets the asynchronous data transfer speed of the WAN port and MUST match the TA
speed setting.
Note: This Async Rate should be left at the <default> setting of 115200.
5. Press
the
È
key to the
ISDN Switch Type
parameter. Press the
Æ
key to select the type of Central
Office (CO) switch being used for the ISDN connection.
Note: Leave the ISDN Switch Type at the “default” setting of National_ISDN. This setting should work
for most types of Central Office switches. If problems occur, contact the local telephone company and
inquire about the switch in use.
6. Press
the
È
key to the
Phone Numbers
menu.
The following menu appears:
Figure 16: Phone Numbers Menu
Note: Press the
Æ
key to enter the appropriate information provided by the system administrator
.
•
Local Dialing Num1
parameter. Enter the DN 1 number assigned to the ISDN line, which was
provided when the ISDN line was installed.
Example:
2881918
•
ISDN SPID 1
parameter. Enter SPID 1 assigned to the first ISDN B-channel.
Example:
40328819180101
•
Local Dialing Num2
parameter. Enter the DN 2 number assigned to the ISDN line.
•
ISDN SPID 2
parameter. Enter SPID 2 assigned to the second ISDN B-channel.
•
Dial Prefix
parameter. Enter the required prefix for dialing out on this WAN port.
Example:
98
•
Dialback Num1
parameter. Enter the telephone number for dialing the first ISDN B-channel of the
EXTender from the PBX location where the Gateway is installed.
Example:
914032881918
•
Dialback Num2
parameter. Enter the telephone number for dialing the second ISDN B-channel of the
EXTender from the PBX location where the Gateway is installed.
7. Press
the
Å
key to accept changes and go back to the Configuration Menu.
8. Press
the
È
key to the
Save
parameter. Press
Enter
to save changes to the active config (.
re
m) file.
