30
NOTE
The Test System command is reserved for MCC manufacturing and
support use only.
Description:
The Select Address command is used to select the bus slave address or addresses
the unit will monitor. During a PRE-TRIG, POST-TRIG, or Remote Trace, the
unit will capture all messages sent to this address.
Entering parameter ALL instructs the unit to collect bus traffic to all slave
addresses.
Entering a slave address parameter specifies a single bus address to monitor.
Slave address selection may also be set with the MONITOR-SELECT or
MONITOR-ALL keys. For more information see the “Introduction” section in
this guide.
Example: SALL<Enter> - Monitor ALL Slave addresses.
S50<Enter> - Monitor slave address 50H.
Syntax: T
Description:
The Test System command invokes manufacturing test functions. This command
is reserved for MCC use only.
Test System
Содержание MIIC-101
Страница 7: ...I2 C Bus SMBus Monitor Model No MIIC 101...