Page 10 of 17
9/1/2010
Connector C214
Fig. 5-18
Fig. 5-17
Fig. 5-16
Yellow / Green
Pin #5
Lower
Connector
Upper
Connector
Fig. 5-15
c) Attach wire tap connector to
Yellow / Green-
striped wire
approximately ½” up from
connector.
(Fig. 5-15)
d) Using pliers, close 2 sides of wire-tap onto wire.
(Fig. 5-15)
5. Connect EC power harness to B+ Constant.
a) Insert male spade terminal of
Solid Black
wire
into opening of wire tap on the
Yellow / Green-
striped
wire
.
(Fig. 5-16)
1. Separate EC harness power and ground wires.
b) Pull power and ground wires apart (approx. 8
inches).
(Fig. 5-17)
5c
Connect B+ Constant and Ignition
2010 and Newer Models
Ensure male spade connector is fully inserted into wire tap.
Check to see that the spade connector did not miss the slot.
Check to see that it is not visible on either side of the female
connector.
CAUTION
!
2. Attach wire tap connector to +12V ignition in lower
20-pin A-pillar connector.
c) Locate
20-pin
connector
(C214
) on driver side
A-pillar.
(Fig. 5-18)
d) Using fiber stick, remove 20-pin connector from
A-pillar
. (Fig. 5-18)
