Maytronics Dolphin WAVE 300 XL, Инструкция пользователя

Страница: 8 / 20

6 Wave XL | User Instructions
5. Using the arrows
 
select the required
pool length. Press Set .
For ft. measure units continue scrolling to the
right using

arrow.
6. Press
Start
. The cleaning session will begin.
The factory default settings are used. In order
to change parameters refer to
Configuring
Additional Pool Profiles on page 9.
The robot starts its cleaning cycle and
the MMI displays the Countdown screen
(Figure-4):
The countdown screen shows that a 4 hour cycle time was selected and that the time remaining is
3 hours, 59 minutes and 59 seconds.
At the end of the cleaning session, the robot stops automatically.
To remove the robot from the pool, proceed as explained in
Removing the Robot from
Swimming Pool on page 6.
To avoid unauthorized changes to the MMI settings you can lock the MMI’s keyboard:
From the
Countdown
screen, press Lock (Figure 4).
To unlock the keyboard, press POOL and then HOME in that order.
7. REMOVING THE ROBOT FROM THE SWIMMING POOL
1. Press HOME .
The robot starts moving in the direction of the floating cable. Roll the floating cable neatly on the
cable roller, using the cable roller handle.
2. Holding the floating cable, gently pull the robot upwards and towards the Caddy. As it reaches the
side of the pool, pull the cable gently until the floating cable handle emerges. Grasp the handle
and pull the robot out of the water. The robot shuts down automatically. By using the remote
control you can drive the robot to the Caddy.
Outside the pool, do not pull the robot towards the Caddy by rolling up the floating cable with the
cable roller handle.
Manual stop control
If necessary, you can stop the robot during
the cleaning session.
1. From the
Countdown screen (Figure 4),
press Stop . The MMI screen displays the
message: “Stopping robot – please wait”.
After 5 seconds the Manual Stop screen
is displayed (Figure 5).
2. To stop the cleaning session completely,
press Exit . The MMI display returns to the
Wave
screen.
lock stop
4 hr
- cycle
CrissCross
03:59:59
hh:mm:s
Figure 4: Countdown screen for 4 hour session
TIP
Figure 5: Manual Stop screen
Manual Stop
exit
Completed Time 01:20
Total Hours
Filter Bag Clean