Maytag MZD2669KE Series, Инструкция по использованию и уходу за холодильником

Страница: 28 / 96

Ice fo r ms in inlet
tube to ice make r
Ref r i g e r ato r is
leakin g wate r
Wate r flow is
slowe r than no r mal
Dispense r wate r
is not cold
Wate r appea r s
cloudy
Pa r ticles in wate r
and/o r ice cubes.
27
PROBLEM POSSIBLE C A USES
Water pressure is low.
Sa dd le valve not open completely.
Freezer temperature is too high.
Plastic tubing was use d to complete
water connection.
Improper water valve was installe d .
Water pressure is low.
Sa dd le valve not open completely.
Improper water valve was installe d .
Copper tubing has kinks.
Water filter is clogge d or nee d s to be
change d .
Water valve not opene d completely.
Refrigerator has been recently installe d .
Water supply in hol d ing tank has been
d eplete d .
Water has settle d into water lines
outsi d e hol d ing tank an d has warme d to
room temperature.
Air or air bubbles in water.
Carbon d ust from water filter cartri d ge.
Concentrations of minerals in water will
form particles when water becomes
frozen an
d melts.
Water pressure must be between 35 to 100 poun d s per
square inch to function properly.
A minimum pressure of 35 poun
d s per square inch is
recommen d e d for refrigerators with water filters.
Open sa dd le valve completely.
See Temperature Controls page 7. Freezer temperature
shoul d be between 0° to 2° F (-18° to -17° C).
The manufacturer recommen d s using copper tubing for
installation. Plastic is less d urable an d can cause
leakage. The manufactu r e r is not r esponsible fo r
p r ope r ty dama g e due to imp r ope r installation o r
wate r connection.
See Connecting the Water Supply pages 4 an d 5. Self-
piercing an d 3
⁄
16
" sa dd le valves cause low water pressure
an d may clog the line over time. The manufactu r e r is
not r esponsible fo r p r ope r ty dama g e due to
imp r ope r installation o r wate r connection.
Water pressure must be between 35 to 100 poun d s per
square inch to function properly. A minimum pressure
of 35 poun
d s per square inch is recommen d e d for
refrigerators with water filters.
Open sa dd le valve completely.
See Connecting the Water Supply pages 4 an d 5. Self-
piercing an d
3
⁄
16
" sa dd le valves cause low water pressure
an d may clog the line over time. The manufactu r e r is
not r esponsible fo r p r ope r ty dama g e due to
imp r ope r installation o r wate r connection.
Turn off water supply an d remove kinks.
If kinks cannot be remove d , replace tubing.
Change water filter (see page 13).
Open water valve completely an d check for leaks.
The minimum flow at d ispenser is approximately
10 flui d ounces in nine secon d s with a new filter in
place or approximately 10 flui d ounces in five secon d s
without a filter.
Allow approximately 12 hours for water in hol d ing tank
to chill.
Discar d first glass of water an d refill.
This is normal when first using the d ispenser an d will
d isappear with use.
Initial water ejecte d through cartri d ge may contain
harmless carbon d ust flushe d from cartri d ge.
Particles are safe for consumption.
Will
d isappear after the first few uses.
Particles are not harmful an d naturally occur in water
supplies.
WH A T TO DO
Troubleshooting