16
4.
Close the bolt holes with the four transport bolt hole plugs.
IMPORTANT:
If the washer/dryer is to be transported, call your
product distributor or installer. To avoid suspension and structural
damage, your washer/dryer must be properly set up for relocation
by a trained professional.
INSTALLING STACKED WASHER/DRYER
Remove Transport System
NOTE:
Slide washer/dryer onto cardboard or hardboard before
moving to avoid damaging floor covering.
IMPORTANT:
Position the washer/dryer so that the rear of the
washer is within approximately 900 mm (3 ft.) of its final location.
There are four shipping bolts in the rear panel of the washer that
support the suspension system during transportation.
IMPORTANT:
Remove the four shipping bolts at the rear of the
washer before operation.
1.
Keep the washer/dryer in the upright position while removing the
shipping bolts.
2.
Using a 13 mm (1/2") wrench, loosen each of the bolts.
3.
Once the bolt is loose, move it to the centre of the hole
and completely pull out the bolt, including the plastic spacer
covering the bolt. Once all four bolts are removed, discard the
bolts and spacers.
