February, 2019
eMAX-MR62e-Man
Page 9 of 16
10. Status LEDs:
At Power-up, LED 1 turns ON then LEDs 2 through 7 are turned ON then OFF in sequence.
The following table describes the LED
’s in the Normal Running mode:
LED
DESCRIPTION
1
On-line = four pulses per second; 0.1 second ON, 0.1 second OFF, OFF for .3 seconds
Off-line: 0.2 second ON, 0.8 second OFF
Waiting for application firmware to be downloaded: .1 sec ON, .1 sec OFF
2
Input IN1 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
3
Input IN2 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
4
Input IN3 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
5
Input IN4 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
6
Input IN5 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
7
Input IN6 Status: OFF = Inactive, ON = Active, Flashing = Fault. See note 2
J1-YELLOW Ethernet speed: OFF = 10 Mb/S, ON = 100 Mb/S
J1-GREEN
OFF = No Link, ON = Good Link, Flashing = Ethernet Activity
Note 2:
If this input is defined, every three seconds the LED is pulsed to its opposite state for 0.1
second, otherwise, the LED is off.
11. IT Security
When installing When installing the eMAX-MR62e, it is important to ensure that it is done in a secure
manner.
Upon installation, the user accounts to the web configuration page should be created with secure
passwords, and that all DIP switches are in the off position for the normal operating mode. The
eMAX-MR62e is shipped from the factory with a default login account, which is enabled when DIP 1
is moved from OFF to ON. The default login user name and password will be available for five
minutes once enabled. Therefore, it is important that at least one user account is defined, and the
DIP switches are set to OFF before the MR62e is commissioned. It is also highly recommended not
to configure the MR62e with an IP address that is accessible from the public Internet.
To further enhance network security, options are available to disable Zeroconf discovery, as well as
the web configuration module itself.
