Maxon EC frameless DT, Руководство по установке

Страница: 12 / 35

Installation
General Rules
«EC frameless DT» Installation Manual
3-12
mmag | 2021-12 | rel10341
3.1 General Rules
Check on the
safety matters and
rules (

page 5)
before you pro-
ceed.
BY PRINCIPLE, THE «EC FRAMELESS DT» COMPRISES PARTS THAT PRODUCE STRONG MAG-
NETIC FIELDS. IT IS THEREFORE MOST IMPORTANT THAT YOU ARE AWARE OF THE CONSE-
QUENCES OF THESE MAGNETIC FORCES, THAT YOU TAKE THE APPROPRIATE PRECAUTION-
ARY MEASURES, AND THAT YOU COMMUNICATE THIS FACT TO PERSONS IN YOUR VICINITY!
BEFORE YOU ENGAGE WITH ANY WORK, READ, UNDERSTAND, AND FOLLOW THE SAFETY PRE-
CAUTIONS AS OF PAGE 5!
OBSERVE THE FOLLOWING NOTICE ON THE PREREQUISITES FOR PERMISSION TO COMMENCE
INSTALLATION.
The «EC frameless DT»
is considered as partly completed machinery according to EU Directive 2006/42/
EC, Article 2, Clause (g) and
is intended to be incorporated into or assembled with other machinery or
other partly completed machinery or equipment
.
Electrostatic Sensitive Devices (ESD)
• Wear electrically conductive clothing and footwear.
• Observe ESD protective measures.
Requirements for operation
The function of the drive is only guaranteed if all specified design characteristics and tolerances are met. Do
only continue if this is actually the case. If this is not the case you must rectify the deviations, first.
Safe, trouble-free, long-term operation is only possible…
• if the defined properties of the outer body (such as housing, machine structure, or carrier system) as well
as the motor shaft and its bearings are met, and
• if centering and axial position of stator and rotor are carried out with sufficient accuracy!
Continued on next page.
WARNING
Risk of injury
Operating the device without the full compliance of the surrounding system with the EU Directive
2006/42/EC may cause serious injuries!
• Do not operate the device, unless you have made completely sure that the other machinery fully com-
plies with the EU directive’s requirements!
• Do not operate the device, unless the other machinery fulfills all relevant health and safety aspects!
• Do not operate the device, unless all respective interfaces have been established and fulfill the
requirements stated in this document!
WARNING
Pinching and shearing risk
Sudden movement and shift of the rotor can cause serious injuries!
To prevent sudden shift during installation you must keep stator and rotor blocked at all times. Do so by
using a mechanical locking device, a mounting aid, or non-magnetic spacers!