Maximum 055-9033-8, Инструкция по эксплуатации

Страница: 18 / 43

ASSEMBLY
35 34
model no. 055-9033-8 | contact us 1-800-689-9928 model no. 055-9033-8 | contact us 1-888-670-6682
ASSEMBLY
Fig. 3c
• Grasp the stand support assembly (7) and lift
it up until two other stand legs (8) raise
off the ground, then fold out two stand legs
(8). To do this, push the lock pins (8) until
they unlock the stand legs (8) from the holes,
then swing the stand legs (8) downward until
the stand legs are locked with the locking
pins (9) engaging the holes. (Fig. 3c) Make
sure the table saw is balanced with four leg
stands firmly on the floor.
• Fig. 3d is the leg stand assembly in an open
position.
•
•
•
•
Lower the blade all the way to down position
by turning the height-adjusting knob (1)
counter-clockwise.
Lock the blade by turning bevel locking lever
(2) clockwise.
To remove the table insert:
Turn the lock
knob (3) counter-clockwise to unlock the
table insert (4). Place your index finger in the
hole, pulling the table insert (4) out toward
the front of the saw.
To reinstall the table insert:
Push the table
insert (4) down and turn the lock knob (3)
clockwise to lock the table insert in place.
•
•
•
TO SECURE/LEVEL THE STAND (Fig. 4)
With the stand open, resting on a level
surface, the stand should not move or rock
from side to side. If the stand rocks from side
to side, the adjustable foot (1) can be adjusted
until the stand is balanced.
Lift the stand slightly so that you may turn
the adjustable foot (1) until the stand no
longer rocks.
Turning clockwise will lower the foot.
Turning counter-clockwise will raise the foot.
TO REMOVE/REPLACE/ALIGN THE TABLE
INSERT (Fig. 5a-5b)
Fig. 4
Fig. 5a Fig. 3d
3
3
1
2
4
8
7
9
WARNING!
Keep your fingers clear of the hinge points while opening
the stand. Danger of fingers being crushed or contused.
WARNING!
The table saw must be secured. A table saw that
is not properly secured may move or tip over.
1
WARNING!
The table insert must be level with the saw table.
If the table insert is too high or too low, the workpiece
can catch on the uneven edges, resulting in binding or
kickback, which could result in serious personal injury.