CAUTION:
This tool is heavy. To avoid back injury, lift with your legs, not your back, and
get help when needed.
WARNING!
Remove the protective polyfoam from between the saw’s housing and the
motor.
WARNING!
The use of attachments or accessories not listed in this manual might be
hazardous and could cause serious personal injury.
WARNING!
Do not attempt to modify this tool or create accessories not recommended for
use with this tool. Any such alteration or modification is misuse, and could result in a
hazardous condition leading to possible serious personal injury.
WARNING!
Do not connect to the power supply until assembly is complete. Failure to
comply could result in accidental starting and possible serious personal injury.
WARNING!
Always make sure the table saw is securely mounted to the stand. Failure to
heed this warning can result in serious personal injury.
WARNING!
To avoid injury, do not connect this table saw to a power source until it is
completely assembled and adjusted and you have read and understood the operator’s
manual.
CAUTION:
Many of the illustrations in this manual show only portions of the table saw. This
is intentional so that we can clearly show points being made in the illustrations. Never
operate the saw without all guards securely in place and in good operating condition.
ASSEMBLY
31
30
model no. 055-9033-8 | contact us 1-800-689-9928
model no. 055-9033-8 | contact us 1-888-670-6682
ASSEMBLY
TOOLS NEEDED FOR ASSEMBLY
Screwdriver
UNPACKING
This product requires assembly.
•
•
•
•
Star-head
screwdriver
Framing square
Triangle square
Wrench
1
4
2
3
Fig. 2a
ASSEMBLE THE STAND (Fig. 2a-2e)
•
•
•
Inspect the tool carefully to make sure that no breakage or damage occurred during
shipping.
Do not discard the packing material until you have carefully inspected and satisfactorily
operated the tool.
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If
shipping has influenced the settings, refer to specific procedures explained in this
Operator’s Manual.
If any part is missing or damaged, do not attempt to assemble the table saw, plug in
the power cord, or turn the switch ON until the missing or damaged part is obtained
and is installed correctly.
Place cardboard or an old blanket on floor in order to protect the surface of the
working table.
Place the table saw assembly upside down on the protective material.
Attach the stand assembly (1) to the table saw
assembly (2) with four flat round head
screws M8 x 45 (3) and four locking nut M8 (4)
(two holes on the side board of the stand
assembly located on the blade wrench
storage). (Fig. 2a)
Содержание 055-9033-8
Страница 1: ......