Maximum 055-9033-8, Инструкция по эксплуатации

Страница: 22 / 43

3
4
2
1
1
1
2
3
•
•
Pull blade guard fully back onto riving knife.
Push pin and release it to lock guard into
position.
If blade guard is not parallel to table when
riving knife is in uppermost position
(through cuts), adjust the set screw (6) as
necessary. (Fig. 9c)
ASSEMBLY
43 42
model no. 055-9033-8 | contact us 1-800-689-9928 model no. 055-9033-8 | contact us 1-888-670-6682
ASSEMBLY
Fig. 9c
•
•
•
RIP FENCE INSTALLATION (FIG. 11a-11c)
Push up the fence rails lever (1) toward the
front of the saw to unlock it.
Loosen the rip fence locking knobs (2) on the
rip fence.
Sliding the rip fence (3) to right and swing it
up at an angle, then remove the fence from
the front and rear fence rails (4).
•
•
•
Holding the fence (3) at an angle, align the
position screws (front and back) on fence
rails with the fence slots.
Slide the slots onto the position screws and
rotate the fence down until it rests on the
rails.
Secure the rip fence in place by turning the
rip fence locking knobs (2) clockwise.
Lock the fence rails lever (1).
•
•
•
•
•
Loosen two stop screws (1) on the extension poles (2) of the outfeed support (3).
Loosen the locking knobs (4) under the working table counter-clockwise.
Insert the rear extension table poles (2) into the two holes in the rear of the working
table and into the extension tube brackets that are located under the working table.
Position the outfeed support.
Thread the locking knobs (4) into the the holes under the working table and tighten
them.
Thread the two stop screws (1) into the holes located on ends of the extension poles
(2) and tighten them.
OUTFEED SUPPORT ASSEMBLY INSTALLATION (Fig. 10a-10b)
Fig. 11a
Fig. 10b Fig. 10a
1
2
6
4
WARNING!
After the installation, check the blade guard to
ensure that it is properly placed and workable
before operating the saw.
3
Fig. 11b
Fig. 11c
6
3
CAUTION:
There are three position screws (5, 6, 7)
on the each front and rear fence rails (4) to
attach rip fence. Position screws (5, 6) use for
rip fence on the right of saw blade. Position
screws (7) use for rip fence on the left of saw
blade. (Fig. 11b)
CAUTION:
The rip fence should be parallel to the
saw blade. If not, refer to the section
“ALIGNING RIP FENCE TO BLADE”.
CAUTION:
Three position screws apply to three
different scales:
Position screw AA: Begin with 0 to 25"
(63.5 cm) end. (Rip fence located on the right
of the blade)
Position screw BB: Begin with 8" (20.3 cm) to
33" (83.8 cm) end. (Rip fence located on the
right of the blade)
Position screw CC: Begin with 19" (48.3 cm) to
0 end. (Rip fence located on the left of the
blade)
2
4
3
3
1
1
AA
0
8
1
9
2
10
21
29
20
28
19
27
22
30
23
31
24 25
32 33
CC
BB
4
5
6
7
2
1