Maximum 055-9033-8, Инструкция по эксплуатации

Страница: 28 / 43

2
2
1
4
3
3
2
2
3
1
2
1
3
Fig. 20g
Fig. 21
Fig. 22
55 54
model no. 055-9033-8 | contact us 1-800-689-9928 model no. 055-9033-8 | contact us 1-888-670-6682
Fig. 20c
•
•
•
•
•
ADJUSTMENT KNOB (Fig. 20g)
The adjustment knob allows smaller
adjustments when setting the rip fence.
Unlock the fence rails locking lever (1).
Slide the rip fence (6) close to the desired
position.
Slowly turn the adjustment knob (7) to set
the rip fence to desired position. Turning the
adustment knob clockwise will extend the
fence rails (8) to right. Turning the adjustment
knob counter-clockwise will extend the fence
rails (8) to left.
Lock the fence rails locking lever (1).
The mitre gauge (1) provides accuracy in
angled cuts. For very close tolerances, test
cut are recommended.
There are two mitre gauge grooves: one on
either side of blade. When making a 90° cross
cut, use either mitre gauge groove. When
making a bevelled cross cut (blade tilted in
relation to working table, mitre gauge
should be located in groove on right so that
blade is tilted away from mitre gauge and
hands.
MITRE GAUGE (FIG. 21)
•
•
•
Loosen lock knob (2) by turning it counter-
clockwise.
With mitre gauge in mitre gauge groove,
rotate gauge until desired angle on scale is
reached.
Retighten lock knob (2) by turning it
clockwise.
The outfeed support (1) slides to give operator
additional support for cutting long workpieces.
OUTFEED SUPPORT (FIG. 22)
•
•
•
Unplug the saw.
Loosen the locking knobs (2) under the
working table counter-clockwise. Stand
behind saw. Grasp outfeed support (1) with
both hands and pull until it is fully extended.
Tighten the locking knobs (2) clockwise.
When cutting narrow workpiece:
(Fig. 20d-20f)
•
•
Loosen the lock lever, rotate the narrow (2)
fence 5° clockwise and hear a “click”, then
turn the locking lever (3) clockwise to lock.
(Fig. 20d)
Secure the rip fence on middle position
screws (front and back) on fence rail with
locking knobs (4). (Fig. 20e)
Fig. 20d
Fig. 20e Fig. 20f
CAUTION:
To lock the narrow fence (2), turn the
locking lever (3) as shown in Fig. 20c until it
presses against the rib.
Make sure the lip fence does not rotate after
you have turned the locking lever (3).
WARNING!
The locking knobs (4) must be locked
in the holes (5) (front and back) above the slot
on the fence rail.
2
2
Rib
6
1
7
8
OPERATION OPERATION
3
3
2
3
5°
4
5
5
2
2
1
2 2
1