CCpilot VC
2.2
Common templates
2017-03-13
w ww.maximatecc.com
23
PWM duty cycle and frequency is adjustable via API/software.
Observe that high continuous current through several I/O channels simultaneously adds internal
heating of the device. At high ambient temperatures, this may cause I/Os to switch off because of
thermal protection in their internal circuitry. Normal function will be restored when temperature is
within acceptable level again. Note, if this occurs frequently it’s recommended to improve the
v entilation around the device or if possible reduce the load on the outputs.
6.
Connectors
All connectors are accessible from the rear of the unit. The connectors which are twelve pin molded-in
Deutsch DTM series connectors are marked with a 1(J1) and a 2(J2).
Use caution and avoid plugging/unplugging of connectors when the computer is powered up. Always
replace damaged cables. If a connector pin becomes bent the interface may not function correctly and
the device should be returned to the manufacturer for repair.
6.1.
Connector layout
Note that descriptions herein refer to the connectors located on the device and not the cable-side
connectors which are attached to the device. Though, the pinout numbering and signal descriptions
are the same.
Pin
Function (DTM06-12SA)
Pin
Function (DTM06-12SB)
J1-1
Constant Power +12/24
J2-1
Configurable Input 1
J1-2
Power Ground
J2-2
Configurable Input 2
J1-3
Switched Power +12/24
J2-3
Video Input 1
J1-4
Switched Output 1
J2-4
Video Ground
J1-5
Switched Output 2
J2-5
Analog Ground
J1-6
CAN 1 Shield
J2-6
CAN 2 Shield
J1-7
CAN 1+
J2-7
CAN 2+
J1-8
CAN 1 -
J2-8
CAN 2 –
J1-9
USB Ground
J2-9
Ethernet TD+
J1-10 USB Data -
J2-10
Ethernet TD-
J1-11 USB Data +
J2-11
Ethernet RD+
J1-12 USB Vbus
J2-12
Ethernet RD-
