Recheck Rear-Facing
Level Line
Redo the installation if the
Level Line
is not parallel
with the ground.
Only if necessary, you may
place a tightly rolled towel(s) or
foam pool noodle(s) under the
front of the car seat to help get
the correct angle to make the
Level Line
parallel with the
ground.
Check the padding often to
make sure it is still in place.
Finished!
Rear-Facing
Vehicle Belt
Install
When used correctly, the AutoLock
will lock the vehicle belt in place.
After the car seat has been
installed, if your car has a
switchable retractor, you
MUST
also use it to lock the belt.
Review pages 21-24 and your vehicle owner’s manual to
determine how to lock the belt with the retractor.
Check the tightness of the install often to make sure it has not
loosened.
IMPORTANT!
DO NOT use the AutoLock
feature when
installing with LATCH: lower anchor belts.
DO NOT
use the lower anchors of the child restraint anchorage
system (LATCH system) to attach this child restraint when
restraining a child weighing more than 35 lb (15.9 kg).
11
Locate Lower Anchor
Belt Storage
Pull the car seat pad off the
front of the car seat to reveal
the LATCH: lower anchor belt
and the
Rear-Facing Belt
Path
.
It may be easier to lift up
the pad if you remove
the cup holders. Twist
counterclockwise and lift
them out of the car seat.
Rear-Facing
LATCH:
Lower Anchor Belt
Install
33
34
1
Before you begin installing the car seat
into your vehicle, did you check:
Your child’s weight and height?
See page 27.
Your child’s fit?
See page 11.
continued on next page
WARNING:
