3
IMPORTANT SAFETY PRECAUTIONS TO PROTECT YOUR
MODEL, YOURSELF & OTHERS
1. This product should not be considered as a toy, but rather a sophisticated, working
model that functions much like a full-scale airplane. Because of its performance
capabilities, the model airplane, if not assembled and operated correctly, could possibly
cause injury to you or spectators and damage to property.
2. Assemble the model airplane according to the instructions. Do not alter or modify the
model, as doing so may result in an unsafe or unworkable model. In a few cases the
instructions may differ slightly from the photos. In those instances the written instructions
should be considered as correct. If you have any question about this instruction, contact
us before you assemble the model.
3. Take time to build straight, TRUE and STRONG.
4. Maxford USA recommends that you use a good quality radio system and our
recommended or same sized good quality motor and components throughout the
building process.
5. Install all R/C and other components correctly so that the model operates correctly on
the ground and in the air.
6. Always check the operation of the model before every flight to insure that all
equipment is operating and that the model has remained structurally sound. Always
check clevises or other connectors and replace them if necessary.
7. If you are not an experienced pilot or have not flown this type of model before, we
recommend that you get the assistance of an experienced pilot.
8. While this kit has been flight tested to exceed normal use, if the plane will be used for
extremely high stress flying, such as racing, or if a motor larger than one in the
recommended range is used, the modeler is responsible for taking steps to reinforce the
high stress points and/or substituting hardware more suitable for the increased stress.
WARNING
Some parts included in this kit are made of fiberglass, the fiber of which may cause eye,
skin and respiratory tract irritation. Never blow into a part to remove fiberglass dust, as
the dust will blow back into your eyes. Always wear safety goggles, a particle mask and
rubber gloves when grinding, drilling and sanding fiberglass parts.
LITHIUM BATTERY HANDLING & USAGE
WARNING!! Read the entire instruction sheet included with the battery. Failure to follow
all instructions could cause permanent damage to the battery and its surroundings, and
cause bodily harm!
• ONLY use a Li-Po approved charger. NEVER use a NiCd/NiMH peak charger!
• NEVER charge in excess of 4.20V per cell.
• ONLY charge through the “charge” lead. NEVER charge through the “discharge” lead.
• NEVER charge at currents greater than 1C.
• ALWAYS set charger’s output volts to match battery volts.
• ALWAYS charge in a fireproof location.
• NEVER trickle charge.
• NEVER allow battery temperature to exceed 150° F (65° C).
• NEVER disassemble or modify pack wiring in any way or puncture cells.
©
2008 Maxford USA www.maxfordusa.com
3
