9
Radio Installation
-Install the rudder and elevator servos into the fuselage. The rudder servo goes in the aft
most cut out and the elevator servo in the middle. If you are using a gas engine the
throttle servo goes in the most forward hole.
-Open the battery hatch. The receiver can be velcroed into position forward of the
throttle servo.
Control Cable Installation
-Tape the ends of the elevator and rudder cables together so you don’t pull them out of
their holes in the fuselage.
-It is best if you start installation with the rudder servo since the elevator cables run
across the top of the rudder servo.
-Center the rudder servo and attach the control cables to the servo arm. When doing so
make sure you do not pull the control cables out of their fuselage exits. Mount the arm
onto the servo.
-Repeat for the elevator servo. Make sure the cables have clean runs inside the fuselage
and are not tangled.
-Attach the clevises to the elevator and rudder control horns.
©
2008 Maxford USA www.maxfordusa.com
9
