39
9.5 gEnERatoR bElt REplacEMEnt
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks from the machine as outlined in Section 9.1.
3) Remove the front shrouds as outlined in Section 9.2.
4) Remove the generator as outlined in Section 9.4.
5) To install a new belt, first put the belt installation tool on the pulley (Figure A).
6) Put the new belt on the installation tool (Figure B).
7) Turn the pulley until the belt is installed. Rotate the pulley at least 3 full rotations to insure that the belt is centered.
8) Reverse Steps 1-4 to re-assemble the unit.
9) Test the Suspension Elliptical for function as outlined in Section 9.21. .
figuRE a
figuRE b
cHaptER 9: paRt REplacEMEnt guidE
Содержание E5X-04
