Matica MC660, Руководство по эксплуатации

Страница: 26 / 48

Full Color Card Printer
72
Both the Ink Ribbon and Transfer Film have been used up.

Replace both the Ink Ribbon and the Transfer Film.
→
See "Changing the Ink Ribbon and Transfer Film" on page 16 for details about
changing the Ink Ribbon and Transfer Film.
Note

If an error occurs during the use of a YMCKK/YMCKH/
YMCKI/YMCFK ribbon, it may be because the card,
which is about to have its rear surface printed on, is fed
into the printer.
Printing will resume if you replace the Ink Ribbon and
Transfer Film. However, take note that the card inside
the printer will be ejected (without printing) if the power
is turned off before replacing the Ink Ribbon and
Transfer Film.
Cards cannot be fed into printer.

Press the SET Key.
Frequent occurrences of this error may mean the following:
Is the Card Case loaded correctly?

Correctly load the Card Case.

Confirm that the Card Case card retainer is loaded properly.
→
See "Loading Cards" on page 10 for instructions on loading cards.
Is the Feeding Roller dirty?

Clean the Feeding Roller located below the Card Case.
→
See "Cleaning the Feeding Roller" on page 61 for Feeding Roller cleaning
instructions.
There was a card jam.

Press the SET Key.
An error occurred, and cards cannot be output.

Remove the cards by rotating the Ejection Dial, and press the SET
Key.
→
See "When a Card is Jammed..." on page 75 for instructions on how to remove
cards.
Frequent card jams could mean the following:
Is the Transport Roller dirty?

Clean the Transport Roller.

If the Transport Roller is excessively dirty, continue cleaning using a
new Cleaning Card.
→
See "Cleaning with a Cleaning Card" on page 56 for instructions on cleaning
the Transport Roller.
Error message Cause and solution
Rbn & Film Empty
Card Jam Feeder
Card Jam F.Turn
Card Jam Print
Card Jam Mg
Operating Manual MC660
Matica Technologies