Matica MC660, Руководство по эксплуатации

Страница: 25 / 48

71
The Transfer Film has been used up.

Replace the Transfer Film.
→
See "Changing the Ink Ribbon and Transfer Film" on page 16 for details about
changing the Transfer Film.
Note

If an error occurs during the use of a YMCFK ribbon, it
may be because the card, which is about to have its
rear surface printed on, has been fed into the printer.
Printing will resume once you replace the transfer film.
However, take note that the card inside the printer will
be ejected (without printing) if the power is turned off
before replacing the transfer film.
The Transfer Film could not be detected correctly.

Reload the Transfer Film.
→
See "Changing the Ink Ribbon and Transfer Film" on page 16 for details about
changing the Transfer Film.

The Transfer Film set in the printer and printer settings may be
different.
→
See "Ink Ribbon/Transfer Film" on page 83 about the supported types of
Transfer Film.
→
See "Setting the Type of Ink Ribbon or Transfer Film to Use" on page 41 for
details on how to set the Transfer Film type.

Transfer Film not supported by this printer cannot be used.
→
See "Ink Ribbon/Transfer Film" on page 83 for types of supported Transfer
Film.
The Transfer Film could not be wound up.

Reload the Transfer Film.
→
See "Changing the Ink Ribbon and Transfer Film" on page 16 for details about
changing the Transfer Film.
The Transfer Film may be cut.

Repair the cut Transfer Film.
→
See "If the Ink Ribbon or Transfer Film are Cut" on page 78 for instructions on
how to repair a cut Transfer Film.

The Transfer Film set in the printer and printer settings may be
different.
→
See "Ink Ribbon/Transfer Film" on page 83 about the supported types of
Transfer Film.
→
See "Setting the Type of Ink Ribbon or Transfer Film to Use" on page 41 for
details on how to set the Transfer Film type.
Error message Cause and solution
Film Empty
Film Type
Film Wind up
Operating Manual MC660
Matica Technologies