SAFETY GUDELINES
This manual contains information that relates to PROTECTING PERSONAL SAFETY and PREVENTING
EQUIPMENT PROBLEMS. It is very important to read this manual carefully and understand it thoroughly
before using the air compressor. The symbols listed below are used to indicate this information.
POTENTIAL HAZARD THAT WILL RESULT IN SERIOUS INJURY OR LOSS OF LIFE
POTENTIAL HAZARD THAT COULD RESULT IN SERIOUS INJURY OR LOSS OF LIFE
POTENTIAL HAZARD THAT MAY RESULT IN MODERATE INJURY OR DAMAGE TO EQUIPMENT
1.
RISK OF EXPLOSION OR FIRE.
Do not spray flammable liquids in a confined area. It is normal for the
motor and pressure switch to produce sparks while operating. If sparks come into contact with vapours from
gasoline or other solvents, they may ignite and cause a fire or an explosion. Do not smoke while spraying.
Do not spray where sparks or flames are present. Keep the air compressor as far away from the spraying
area as possible. Always operate the compressor in a well-ventilated area.
2.
RISK OF ELECTRIC SHOCK.
All wiring must be installed by a licensed electrician, in accordance with all
local and national codes. In order to avoid electric shock, do not use an electric air compressor outdoors
when it is raining or on a wet surface.
3.
RISK OF BURSTING.
Rust can weaken the tank. Drain the condensed water from the tank after each
use in order to reduce rusting. Welding or making modifications to the air tank can severely diminish the
strength of the tank, and could cause an extremely hazardous condition. Do not weld, drill, or modify the
air tank. If a leak is detected in the tank, replace the tank immediately.
4.
RISK OF INJURY.
Be sure to shut off the air compressor, unplug it from the outlet, and bleed all pressure
from the system before servicing the compressor or when it is not in use. Do not use the compressor with
the shrouds removed. Contact with moving parts could cause serious injury.
5.
RISK OF BURSTING.
Check the maximum pressure rating in the manual or the serial tag label. The
compressor outlet pressure must be regulated so that it does not exceed the maximum pressure rating.
Relieve all pressure in the hose before removing or attaching accessories.
6.
RISK OF BURSTING.
Do not adjust the pressure switch or relief valve for any reason. They have been
preset at the factory for this compressor’s maximum pressure. Tampering with the pressure switch or the
relief valve may cause personal injury or property damage.
7.
RISK OF BURNS.
The pump and the manifold generate high temperatures. In order to avoid burns or
other injuries, do not touch the pump, the manifold, or the transfer tube while the compressor is running.
Allow the parts to cool down before handling or servicing. Keep children away from the compressor at all
times.
8.
RISK TO BREATHING.
Carefully read all labels when you are spraying paints or toxic materials, and
follow the safety instructions. Use a respirator
mask if there is a chance of inhaling anything that is being
sprayed. Do not directly inhale the compressed air produced by a compressor.
9.
RISK OF EYE INJURY.
Wear ANSI Z87.1 approved safety goggles when using an air compressor. Do
not point any nozzle or sprayer toward a person or any part of the body. Serious injury may occur if the
spray penetrates the skin.
1. Pull the pressure relief valve ring every day in order to ensure that the valve is functioning properly.
2. The compressor must be located in a well-ventilated area for cooling, and must be a minimum of 12‘’ (30 cm) away
from the nearest wall.
3. Protect the air hose and the power cord from damage and puncture. Inspect them for weak or worn spots every
week, and replace them if necessary.
4. Always wear hearing protection when using an air compressor. Failure to do so may result in hearing loss.
5. Do not operate the air compressor if it is not in a stable position. Do not operate the air compressor on a rooftop or
an elevated position that could allow the unit to fall or be tipped over.
3
Содержание 058-7947-0
Страница 12: ...PARTS SCHEMATIC 12...
