MasterCraft 058-7947-0, Руководство пользователя

Страница: 7 / 14

BEFORE YOU START - ASSEMBLING THE COMPRESSOR
1. Unpack the air compressor. Inspect the unit for damage .If the unit has been damaged in transit, contact the
carrier and complete a damage claim, Do this immediately because there is time limitation to damage claims.
The carton should contain:
Air compressor,
Accessories,
Instruction manual.
2. Check the compressor’s identification label to ensure that you have received the model ordered, and that it has
the required pressure rating for its intended use.
3. Locate the compressor according to following guidelines:
a. Position the compressor near a grounded electrical
b. The compressor must be at least 12” (
30 cm) from any wall or obstruction, in a clean, well-ventilated area,
to ensure sufficient air flow and cooling.
c. In cold climates, store portable air compressors in a heated building when not in use. This will reduce
problems with motor starting and freezing of water condensation.
d. Place air compressor on the floor or a hard, level surface. The air compressor must be level to ensure
proper drainage of the moisture in the tank.
4
.
Connect an air hose to the compressor hose outlet. (see Figure 2)
5.
Refer to the air compressor‘s identification label for the unit’s voltage and amperage requirements.
USE A SEPARATE CIRCUIT
For best performance and reliable starting, the air compressor should be plugged into a dedicated
circuit,
as close as possible to the fuse box or circuit breaker .
The compressor will use the full capacity of a typical 15-A household circuit. If any other electrical devices are
drawing from the air compressor’s circuit, the air compressor may fail to start. Low voltage or an overloaded
circuit can result in sluggish starting that causes the motor overload protection system or circuit breaker to trip,
especially in cold conditions.
NOTE: A circuit breaker is recommended. If the air compressor is connected to a circuit protected by a
fuse, use dual element time delay fuses (Buss Fusetron type “T” only).
Figure 2
7