MasterCraft 055-6739-8, Руководство пользователя

Страница: 24 / 48

24
switch to turn it ON.
TO TURN YOUR SAW OFF: Press the
switch down to turn it OFF.
TO LOCK YOUR SAW: Press the switch
down. Remove the switch key from
the switch, and store in a safe, secure
location.
WARNING! Always remove the
switch key when the tool is not in use,
and keep it in a safe place. In the event
of a power failure, turn the switch OFF
and remove the key. This action will pre-
vent the tool from accidentally starting
when the power returns.
WARNING! ALWAYS make sure your
workpiece is not in contact with the blade
before operating the switch to start the
tool. Failure to heed this warning may
cause the workpiece to be kicked back
toward the operator, and may result in
serious personal injury.
WARNING! To reduce the risk of accidental starting, always make sure the
switch is in the OFF position before plugging the tool into the power source.
OVERLOAD PROTECTION
This saw is equipped with a resettable overload protection. If the motor shuts
off or fails to start due to an overload or low voltage, turn the switch to the
off position and allow the motor to cool down for at least five minutes. After
the motor has cooled down, push the reset button (located under the base –
refer to the indicated arrow) in order to reset the overload protection. The saw
should now start when the switch is returned to the on position.
SAW BLADE
CAUTION:
Use ONLY 10” (254 mm) diameter blades with 5/8” (16 mm)
arbor holes rated at 6000 RPM or higher.
1. The saw blade furnished with your new saw is a 10” (254 mm) fine
ripping blade, used for ripping (with the grain) through the material,
and occasional crosscuts. The centre hole to fit on the arbor is 5/8”
(16 mm) in diameter. This blade will produce a good quality cut for many
applications.
Fig. 22
SWITCH ON
SWITCH OFF
SWITCH KEY
SWITCH IN LOCKED POSTION