MasterCraft 055-6739-8, Руководство пользователя

Страница: 15 / 48

15
NOTE: When raising the spreader, exert a small amount of force from the left
side.
To place it in the riving knife position (or “down” position for all non-
through cutting)
1. Unplug the saw.
2. Remove the throat plate
3. Raise the saw blade as high as it will go by turning the Height/bevel-
adjusting hand wheel clockwise, and set the blade perpendicular to the
table.
4. Unlock the release lever by pivoting it to the vertical position.
5. Pull the riving knife toward the release lever in order to disengage it from
the slots.
6. Push the riving knife down until the internal slots engage and the spreader
is below the saw blade.
7. Reinstall the throat plate.
CHECKING SAW BLADE INSTALLATION (See Fig.7)
CAUTION! In order to work properly, the saw blade teeth must point down
toward the front of the saw. Failure to heed this warning could cause damage
to the saw blade, the saw, or the workpiece.
NOTE: The arbor shaft has right-hand threads.
1. Unplug the saw.
2. Remove blade wrenches from the
storage area by unscrewing the
locking knob.
3. Lower the saw blade, and remove
the throat plate.
4. Make sure the bevel-locking lever
is securely tightened. Raise the saw
blade to its full height by turning the
Height/bevel-adjusting hand wheel
clockwise.
To loosen the blade:
1. Using the open-end wrench, place the flat open-end on the flat surfaces
on the arbor shaft.
2. Insert the closed-end wrench over the hex nut. Holding both wrenches
firmly, pull the closed-end wrench toward the front of the machine.
To tighten the blade:
Fig. 7