Master 8053670892743, Руководство пользователя и по эксплуатации

Страница: 8 / 19

WARNING: BEFOR INITIATING ANY REPAIR OR MAINTENANCE PROCEDURE UNPLUG
THE FEEDER CABLE AND MAKE SURE THAT THE HEATER IS COOLED DOWN.
COMPONENT MAINTENANCE FREQUENCY MAINTENANCE PROCEDURE
Fuel tank Clean every 150-200 hours of
operation or when necessary
Empty and rinse with fresh fuel
Nozzle
Clean or replace once per season or
when necessary
Contact the technical service center
Photocell Clean once per season or when
necessary
Contact the technical service center
Fuel filter Clean or replace twice per season or
when necessary
Clean the fuel filter with clean fuel
Ignition device Clean or replace every 1.000 hours
of operation, or when necessary
Contact the technical service center
Fan blades
Clean when necessary Contact the technical service center
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Heater
doesn’t run
1. Heater blocked
2. The power switch is in the “OFF”
(0) position
3. No power
4. Feeder cable unplugged
5. Blocked control card
6. Wrong thermostat setting
7. Temperature sensor override
8. Fuse damaged
1. Restart the heater
2. Turn the switch “ON” (|)
3A. Plug the feeder cable properly into
the socket
3B. Check the power supply network
3C. Contact the technical service center
4. Contact the technical service center
5A. Restart the heater
5B. Identify the display error
5C. Contact the technical service center
6. Calibrate the thermostat by setting it
higher than ambient temperature
7A. Wait at least ten minutes then try to
run ignition again
7B. Contact the technical service center
8. Contact the technical service center
Motor/pump
runs but the
flame does
not start
1. No fuel
2. Ignition device is dirty
3. Fuel filter is dirty
4. Nozzle is dirty
5. Photocell is dirty, damaged or
installed improperly
6. Foreign substances present in
the tank
7. Electrodes are used up or
placed at an improper distance
1. Turn off the heater, refill the fuel tank
then restart the heater
2. Contact the technical service center
3. Clean the filter using clean fuel
4. Contact the technical service center
5. Contact the technical service center
6. Empty and refill the fuel tank with
clean fuel
7. Contact the technical service center
Fan blocked
or spins too
slowly
1. Engine damaged 1. Contact the technical service center
en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh