diode. If the diode is reverse biased or there
is an open circuit the reading displayed will
be
“OL”.
CAPACITANCE MEASUREMENT
1.
2.
3.
4.
Insert the black and red test leads into the
COM
and
V
Hz
input terminals respectively.
Set the rotary switch to position.
Connect test leads across the capacitor
under measurement and be sure that the
polarity of connection is observed. The
polarity of the red lead connection is positive
“+”.
Read the measure result from the display.
FREQUENCY MEASUREMENT
1.
2.
3.
Insert the black and red test leads into the
COM
and
V
Hz
input terminals respectively.
Set the rotary switch to
Hz
position.
Connect the test leads across the source or
load under measurement. The polarity of the
red lead connection is positive “+”.
12
4. Read the measure result from the display.
NOTE:
1.
2.
The signal amplitude must also be greater
than the sensitivity level.
Determine that the amplitude level of the
signal to be measured is not greater than the
input voltage limit (250V DC/AC rms.).
ADP MEASUREMENT
It is standby for user.
1.
2.
3.
Insert the black and red test leads into the
COM
and
V
Hz
input terminals respectively.
Set the rotary switch to ADP position.
DCV
≤
600mV .
SPECIFICATIONS
Accuracy:
±
% of reading
±
number of least significant digits
at 18
℃
to
28
℃
,
with relative
humidity up to 75%.
All specifications assume less than 1 year since
calibration. Temperature coefficient:
0.1
×
specified accuracy/
℃
.
13
