Maserati Levante 2019, Руководство пользователя

Страница: 394 / 454

7
394
Maintenance and Care
To Reconnect the Battery
CAUTION!
•
It is essential when replacing the
cables on the battery that the
positive cable is precisely attached to
the positive post (
+ ) and the negative
cable is attached to the negative post
(
–
).
• Cable clamps should be tight on the
terminal posts and free of corrosion.
After the battery has been
disconnected and re-connected
and before starting the engine it is
necessary to proceed as follows:
• Unlock and lock the doors using the
Key fob RKE Transmitter.
• Close manually the liftgate, unlock
it with the key fob RKE transmitter
and then lock it manually on more
time. If the vehicle is equipped with
power liftgate, manually perform
the complete closure. Then move
the liftgate automatically, using the
buttons on the outer edge of the
left boot compartment, performing
a complete cycle of opening and
closing. If the limit of maximum
power liftgate opening has been set,
it is necessary to reset it (see “Open
and Close the Liftgate” in section
“Before Starting”).
• Initialise the climate control system
by activating the system and pressing
the “AUTO” control as described in
chapter "Air Conditioning Controls"
in section “Dashboard Instruments
and Controls”.
• Turn on the MTC+ and set the date
and time (see “MTC+ Settings” in
section “Dashboard Instruments and
Controls”).
• Lift, release and lift again the lever
on the central console to initialise the
electric parking brake. Following this
operation the
warning light on
the instrument cluster will turn off.
• For correct activation of the approach
lights on the external mirrors, press
at least once the tilt button on the
driver's door panel so that the door
mode recognizes the mirrors position.
• If the car is equipped with power
sunshades on rear door windows,
carry out the teach-in cycle described
on chapter “Power Sunshades on
Rear Door Windows” in section
“Before Starting”.
• Start the engine and perform the
end-stop learning of EPS, steering
fully to the left and then to the right.
The EPS failure warning light and
message should disappear on the TFT
display.
CAUTION!
•
Every time the battery is
reconnected, wait at least 30 seconds
with the ignition switch turned to
RUN before starting the engine, in
order to allow the electronic system