Maserati Levante 2019, Руководство пользователя

Страница: 195 / 454

4
195
Dashboard Instruments and Controls
The current system setting is shown
in blue on the right side of the ABSA
soft-key. Touching this soft-key the
set page of ABSA system will be
displayed (see picture).
Driver warnings can be only “Visual”,
“Visual & Acoustic” (default mode) or
“Visual & Haptic”.
System response can be set to
“Early”, “Medium” (default mode)
and “Late”.
System reaction force can be set to
“Low”, “Medium” (default mode)
and “High”.
See “Active Blind Spot Assist - ABSA”
in section “Driving” for more details.
• Forward Collision Warning (with
active braking)
The FCW feature primary use the
front radar and the forward looking
camera for sensing vehicle and
pedestrian (if the car is equipped
with Pedestrian Emergency Braking
- PEB function) ahead, provide
warnings to the driver and may
perform brakings and brake jerks (if
set).
The current system setting is shown
in blue on the right side of the FCW
soft-key.
Touching this soft-key the set page
of FCW system will be displayed (see
picture).
FCW is always active: it is possible to
set the sensitivity and the aid of the
active braking.
FCW sensitivity can be set to “Near”,
to “Medium” or to “Far”.
The default status of FCW is the
“Medium” setting. Setting it to “Far”
means the system will warn you of
a possible collision with the vehicle
or pedestrian (if the car is equipped
with Pedestrian Emergency Braking -
PEB function) in front of you when
you are farther away. This gives
you the best reaction time, though
could lead to some more unwanted
warnings.
“Medium” gives instead a little less
time for reacting compared to “Far”,
but at the same time should lead to
less not desired warning.
To change the setting for more
dynamic driving, select the “Near” setting. This warns you of a possible
collision when you are much closer to
the vehicle or pedestrian (if the car is
equipped with Pedestrian Emergency
Braking - PEB function) in front of
you.
FCW with active braking can be set to
“On” or “Off”.
• Surround View Camera
Activating this feature the system
uses four cameras to monitor the
area around the vehicle when
transmission lever is shifted to P
(Park), N (Neutral) or D (Drive)
position.
When activation occurs by touching
the “Surround Camera” soft-key in
the “Controls” screen or moving the
shift lever in R (Reverse) position, the
initial view will be the default view
(associated with current gear state).
Image will be displayed with active