Maserati Grecale 2022, Руководство пользователя

Страница: 302 / 324

8
300
Maintenance and Care
quick coupling from the negative post
(
–
) of the battery.
•
If the battery needs to be removed
from its compartment, you must first
detach the terminal clamp to the
negative post (
–
) and then the other
terminal clamp to the positive post ( + ),
after removing the protective cover.
Battery posts are marked positive (
+ )
and negative (
–
) and are identified on
the battery case.
To Reconnect the Battery
CAUTION!
• It is essential when reconnecting the
cables on the battery that the positive
cable is precisely attached to the
positive post (
+ ) and the negative cable
is attached to the negative post (
–
).
• Cable clamps should be tight on the
terminal posts and free of corrosion.
After the battery has been disconnected
and re-connected and before starting
the engine it is necessary to proceed as
follows:
• Unlock and lock the doors using the key
fob.
• Close manually the liftgate, unlock
it with the key fob and then lock it
manually on more time. Then move the
liftgate automatically, using the buttons
on the right side of the outer edge of
the liftgate, performing a complete
cycle of opening and closing. If the limit
of maximum power liftgate opening
has been set, it is necessary to reset it
(see “Open and Close the Liftgate” in
section “Before Starting”).
• Initialise the climate control system by
activating the system and pressing the
“AUTO” control as described in chapter
"Air Conditioning Controls" in section
“Dashboard Instruments and Controls”.
• Turn on the MIA and set the date and
time.
• Lift, release and lift again the lever
under the driver lower side of the
dashboard to initialise the electric
parking brake. Following this operation,
at the next key cycle, the
warning
light on the instrument cluster will turn
off and the error messages regarding
the unavailability of the radar functions
will also no longer be present.
• Start the engine and perform the end-
stop learning of EPS, steering fully
to the left and then to the right. The
EPS failure warning light and message
should disappear on the cluster display.
CAUTION!
•
Every time the battery is reconnected,
wait at least 30 seconds with the
ignition device set in
ON before
starting the engine, in order to allow
the electronic system that manages
the motor-driven throttles to run a
self-learning cycle. At the same time,
you can run the date and time set up
procedure for the MIA.
• Every time the battery is reconnected
the warning lights
and flash
for about 10 seconds and then go off.