Maserati Grecale 2022, Руководство пользователя

Страница: 173 / 324

5
171
Starting and Driving
Aero 2
During transition from one position to
another, the instrument cluster display
will show a pop up indicator which
reproduces the ride height symbols. On
this soft-key, when vehicle is raising,
an
arrow starts blinking together
with the corresponding target height
indicator; in the same way, when vehicle
is lowering, a
arrow is displayed.
When the target height indicator is
reached, it stops blinking and the
corresponding arrow will disappear.
The new position will be displayed on
the dedicated area underneath the left
dial and the indicator will turn off after
approximately 15 seconds when raising
and 5 seconds when lowering by one
level.
The system requires that the engine be
running for all changes, except when
lowering. When lowering the vehicle,
all of the doors, including the liftgate,
must be closed. If a door is opened at
any time while the vehicle is lowering,
the change will not be completed until
the open door/s is/are closed within 5
seconds.
The pneumatic suspension system of
this vehicle uses a lifting and lowering
pattern preventing the headlights from
incorrectly shining into oncoming traffic.
When raising the vehicle, the rear of the
vehicle will move up first and then the
front.
When lowering the vehicle, the front
will move down first and then the
rear. After the engine is turned off, it
may be noticed that the pneumatic
suspension system operates briefly,
this is normal. The system is correcting
the position of the vehicle with little
suspension movements to ensure a
proper appearance.
Display Messages
After changing position, a pop up
message will indicate for 5 seconds
when set position has been reached
(after pneumatic suspension system
intervention that might last up to 30
seconds).
This type of message will be displayed
only if the option to view all pneumatic
suspension system messages and not
only the warnings was set. For further
details, refer to “Functions of Settings
Menu on MIA” in section “Dashboard
Instruments and Controls”.
Set ride height can be monitored on
Comfort display via “Suspension” menu.
The change from one position to
another can occur only if the following
requirements are met.