MASCHIO GASPARDO G, Использование и обслуживание

Страница: 56 / 62

cod. F07011375
cm 35
1
Fig.31
Fig.32
USE AND MAINTENANCE
ENGLISH
56 - EN
advisable to adjust the lift unit of the tractor so that the implement
itself is not raised more than about 35 cm from the ground (Fig. 33).
Do not drive on public highways if the machine is dirtied with
soil, grass or anything else that could dirty and/or hamper the
road traf
fi
c.
Lower the machine slowly to allow the blades to gradually pen-
etrate the soil. Do not allow it to drop violently on to the ground.
To do this would strongly stress all the machine components and
could damage them.
DANGER
Stones or other sharp objects may be thrown up by the turning
tines during the soil working phase.
Always constantly check that there are no persons, children or
domestic animals in the
fi
eld of action of the machine.
The operator must also pay attention to the above.
4.18 TROUBLESHOOTING HINTS FOR THE
TRACTOR OPERATOR/DRIVER
Insuf
fi
cient depth
a) Check the positioning of the two depth skids or of the roller, if
present.
b) Move forward more slowly as the power of the tractor may be
insuf
fi
cient.
c) If the earth is too hard a second or third hoeing may be neces-
sary.
d) If the hoe blades are rotating on top of the earth instead of cutting
into it, increase the working depth and proceed more slowly.
The earth is not broken up
fi
nely enough
a) Lower the levelling blade.
b) Reduce the tractor speed.
c) Don’t work earth that is too wet.
d) In the machine
fi
tted with a levelling bar, raise or lower this so
as to keep the sods closer to the hoe blades
.
Clogging up of the rotor
a) The earth is too wet for hoeing.
b) Raise the levelling blade.
c) Reduce the tractor speed.
d) Reduce the number of hoe blades per
fl
ange from 6 to 4.
e) Avoid choeing where there is long grass and carefully clean
whatever debris has gathered on the supports on the sides of
the rotor to avoid overheating.
The machine bounces over the earth or vibrates
a) There are foreign bodies caught between the hoe blades.
b) The hoe blades have been incorrectly
assembled thereby
not forming the helix shape or with the blunt edge placed to cut
into the earth
fi
rst instead of the cutting edge.
c) Worn or broken hoe blades.
d) The rotor is deformed because of blows to the central part
caused by foreign bodies present during hoeing.
e) Cardan shaft in wrong position (see Fig.4)
Other problems
The machine does not hoe to the same depth over the whole width
e.g. if it hoes too deeply on the right side shorten the right arm of
the lift bars and regulate the position of the right-hand skid.
Working a hill/slope
Where possible always try to «work up» the slope. If this is not
possible avoid hoeing along the contours of the hill and hoe up
and down the slope to avoid a terracing effect.
Practical notes
The hoed earth should be on the right of the driver.
The best system is to hoe alternate strips.
4.19 PARKING
WARNING
Comply with the following instructions in order to ensure
that the machine remains stable when released from the
tractor:
1) Lower the machine to the ground.
2) Check that the machine is stored on a suitable surface.
3) Hold the cardan shaft with a suitable support (1 Fig.32).