Warnings: Installing the disk brake
Installing the brake system is a delicate and critical operation that must be carried out by an authorized Marzocchi Service Center.
Marzocchi is not responsible for the installation and accepts no liability for damage and/or accidents arising from this operation.
Improper installation of a disk brake system can overstress the caliper mountings, which may cause the caliper mountings to break, resulting in loss
of control of the bicycle, an accident, personal injury, or death. Be sure that the brake system installation is also performed in strict compliance with
the instructions provided by the brake system manufacturer.
Improper installation can result in an accident, personal injury, or death.
Use only brake systems that comply with the forks specifications.
The brake cable must never touch the crown and stanchions.
Warnings: Assembling the wheel
For a correct operation of the fork, install the wheel as explained below:
Insert the wheel axle (
1
) through the right dropout, the wheel and the left dropout.
With the 6mm Allen wrench, tighten the left screw (
2
) to the recommended tightening torque (
15 Nm ±
1
).
Check the correct fork-wheel alignment by fully compressing the fork a few times. The wheel should not
come into contact with any parts of the fork.
Lift the front wheel above the ground; turn the wheel a few times to verify the correct alignment with the
disk brake. Read the instructions of the brake system manufacturer for the correct specifications.
With a 5mm Allen wrench, tighten the screws (
3
) on both dropouts to the recommended tightening
torque (
10 Nm ± 1
) following the sequence 1-2-1.
© Marzocchi Suspension
2005
-
Shiver DC
