Tighten the threaded pin (
2
) on the cartridge rod being careful not to damage the O-ring.
With the 10mm and 7.5mm spanners, tighten locknut (
1
) on the threaded pin (
2
) to the recommended
tightening torque (
6 Nm ± 1
).
Insert the complete cartridge (
5
).
Using a 15mm socket spanner, tighten the bottom nuts (
8
) with O-rings (
9
) to the recommended
tightening torque (
10 Nm ± 1
).
Assembling: Filling with oil
Block the fork in the vice in perfectly vertical position.
Fully lower sliders and cartridges.
© Marzocchi Suspension
2005
-
Shiver DC
