Warnings: Installing the handlebar mount
For a correct installation of the handlebar mount, follow the instructions below:
Install the bottom handlebar mount (
1
) onto the top crown so that the fixing holes match.
With a 5mm Allen wrench, lock the handlebar mount tightening screws (
2
) to the recommended
tightening torque (
10 Nm ±1
).
Fit the handlebar right in the middle of the mount.
Lock the handlebar in position with the special U-bolt (
3
).
With a 5mm Allen wrench, tighten screws (
4
) to the recommended tightening torque (
10 Nm ±1
).
On request, special adapters (
5
) are available to install handlebars with a different diameter.
© Marzocchi Suspension
2005
-
Shiver DC
