MARUTI SUZUKI Automobile, Руководство пользователя

Страница: 131 / 177

130
CAUTION
To tighten the oil filter properly, it is
Important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
5) Tighten the filter specified turn from
the point of contact with the mounting
surface (or to the specified torque)
using an oil filter wrench.
Tightening torque for oil filter
• Petrol Engine
3/4 turn or
14 Nm (1.4 kg-m, 10.5 lb-ft)
• Diesel Engine
3/4 turn or
25 Nm (2.5 kg-m, 18.1 lb-ft)
CAUTION
To prevent oil leakage, make sure
that the oil filter is tight, but do not
over-tighten it.
Refill with Oil and Check for Leaks
1) Pour oil through the filler hole and
install the filler cap.
For the approximate capacity of the
oil, refer to the “CAPACITIES” item in
the “SPECIFICATIONS” section.
2) Start the engine and look carefully for
leaks at the oil filter and drain plug.
Run the engine at various speeds for
at least 5 minutes.
3) Stop the engine and wait about 5
minutes. Check the oil level again and
add oil if necessary. Check for leaks
again.
CAUTION
• When replacing the oil filter, it is
recommended that you use a
genuine MARUTI replacement filter.
If you use an aftermarket filter, make
sure it is of equivalent quality and
follow the manufacturer’s instruc-
tions.
• Oil leaks from around the oil filter
or drain plug indicate incorrect
installation or gasket damage. If
you find any leaks or are not sure
that the filter has been properly
tightened, have the vehicle
inspected by your MARUTI SUZUKI
dealer.
Gear Oil
Manual Transmission Oil
When adding gear oil, use the appropriate
viscosity and grade.
We highly recommend you use:
API GL-4 SAE 75W-90 for manual
transmission oil
Gear Oil Level Check
62J080
(1) Oil filler and level plug
To check the gear oil level, use the
following procedure:
1) Park the vehicle on a level surface with
the parking brake applied. Then, stop
the engine.
2) Remove the oil filler plug (1).
3) Feel the inside of the hole with your
finger. If the oil level comes up to the
INSPECTION AND MAINTENANCE
8-11