Martin JEM ZR44 Hi-MASS, Руководство пользователя

Страница: 11 / 28

Installation and setting up 11
Check that the local AC voltage is appropriate, as indicated on the machine’s
serial number label. If your AC voltage is outside the appropriate range, do not
use the machine. Contact Martin Service for assistance.
S e t t i n g u p
Fill the fluid tank with Martin approved fog fluid (see page 16).
If DMX control is being used, connect the machine to the DMX line (see page
14).
F i n a l c h e c k s
Before applying power to the fog machine, verify the following:

the machine is safely located or installed and meets the location
requirements stated on page 10

the operator is familiar with, and able to comply with, the requirements
for safe operation listed on page 4

the fog fluid is one of the genuine Martin fluids listed under “Approved
fluid types” on page 16
 the machine is electrically grounded (earthed)
 the AC power distribution circuits and lines are adequately rated for the
current load
T u r n i n g o n t h e p o w e r
Turn on the main power switch located next to the power cable inlet.
The green ‘Ready’ indicator on the rear of the machine will flash for about 10
minutes as the machine heats up to operating temperature.
When the green Ready indicator stops flashing and is permanently on, the
machine is ready to make fog.