Martin JEM ZR44 Hi-MASS, Руководство пользователя

Страница: 9 / 28

Quick Start 9
Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot
of fog. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
S e t t i n g u p
Locate the machine in a suitably large area with nothing in front of the fog
output.
Fill the fluid tank with Martin approved fluid (see page 16).
Connect the machine to a suitably rated power source. The power requirements
are:
EU Models - 1890 W, 220-240 V
US Models – 1890 W, 100-130 V
Now set the mains switch, at the rear of the machine, to the ‘ON’ position and
press the grey “stand-by” button.
The ‘Ready’ LED will flash indicating the machine is heating up; allow around
10 minutes for the machine to reach operating temperature. Once the machine
has heated the ‘Ready’ LED will stop flashing and be permanently on.
M a k i n g f o g
Once the machine has heated up, hold the FOG button on the remote to start
the fog output.
It may be necessary to prime the machine, to do this simply hold down the FOG
button and turn the output knob to maximum. Keep the button held until the fog
output is strong and steady. Then turn the knob back to the required output
level and release the FOG button.
You can set the fog density by turning the knob. If the knob is turned fully
counter-clockwise, no fog will be produced.