Martin JEM ZR44 Hi-MASS, Руководство пользователя

Страница: 10 / 28

10 Installation and setting up
Installation and setting up
DANGER! DO NOT operate the fog machine until you have read and observed
all the precautions listed under “Safety information” on page 4.
L o c a t i o n
The fog machine may be located on the floor or may be suspended using the
hanging bracket. If suspending the machine, a standard hanging clamp
(available from Martin) should be attached to the machines hanging bracket with
an M12 bolt and nyloc nut.
Additionally, a secondary backup device, a safety cable
(available from Martin) should be looped around the hanging bracket.
The machine can operate in any orientation from 45 degrees upwards to 45
degrees downwards. Steeper tilting may cause fluid leakage.
If the machine is to be suspended, ensure the mounting surface can support the
weight of the machine. Do not suspend the machine over areas where people
will be underneath.
Ensure that there is at least 100 mm (4 in.) clearance around the machine and at
least 600 mm (24 in.) in front of the fog output.
A C p o w e r
Before using the machine, ensure that a grounding-type (earthed) power plug
that fits the local power outlets is installed on the power cable.
DANGER! Make sure the power plug is correctly rated:
• For EU models use a plug rated at 10 A minimum
• For US models use a plug rated at 20 A minimum
When installing the plug, follow the plug manufacturer’s instructions and
connect pins as follows:
Yellow and green wire to ground (earth), blue wire to neutral and brown wire to
live.
The table below shows some common pin identification schemes.
wire function marking screw colour
brown live “L” yellow or brass
blue neutral “N” silver
green/yellow earth green
Before connecting the fog machine to power, verify that the AC supply is
adequately dimensioned for the current draw of the machine. The machine
requires:
EU Models - 1890 W, 220-240 V
US Models – 1890 W, 100-130 V