Martin JEM Compact Hazer Pro, Руководство пользователя

Страница: 11 / 30

Installation and setting up 11
Check that the local AC voltage is appropriate,
as indicated on the machine’s
serial number label. If your AC voltage is outside the appropriate range, do not
use the machine. Contact Martin Service for assistance.
S e t t i n g u p
Fill the fluid tank only with JEM C-Plus Haze Fluid (see page 19).
If DMX control is being used, connect the machine using DMX cable (see page
17). If the JEM Digital Remote Control (optional accessory) is being used
connect the remote to the Remote socket (see page 16).
F i n a l c h e c k s
Before applying power to the haze machine, verify the following:

the machine is safely located or installed and meets the location
requirements stated on page 10

the operator is familiar with, and able to comply with, the requirements
for safe operation listed on page 4.

the haze fluid is one of the genuine Martin
fluids listed under “Approved
Haze fluid
” on page 19.

the machine is electrically grounded (earthed)

the AC power distribution circuits and lines are adequately rated for the
current load
T u r n i n g o n t h e p o w e r
Turn on the main power switch located next to the power inlet. Select STBY from
the RUN menu. The display will show HEAT , then after about 60 seconds the
display will show RDY and the machine is ready to produce haze.
T u r n i n g o f f t h e p o w e r
The JEM Compact Hazer is designed to run a self-cleaning cycle before power
down to help prevent blockages. The cycle takes 45 seconds.
Before
disconnecting the power you should start the cleaning cycle by pressing the
Shutdown Switch on the rear of the unit above the DMX connectors. The red
LED in the shutdown switch will be lit if a cleaning cycle is needed.
If a cleaning cycle is needed, t
he display will show “
WAIT
”, then “
WT44
” counting
down to “
WT00
”. During this time the unit purges the fluid from its internal
pipework to help prevent blockages.
When the display shows “
OFF
” the power may be turned off.
Do not turn off the power without using the Shutdown switch.
This will cause the unit to enter a cleaning cycle when next
switched on, and over time will lead to blockages and
malfunction of the unit.
The cleaning cycle on power up is shown on the display as
WT44
” counting
down to “
WT00
”, as for the shutdown cycle. Once the display reaches “
WT00
”,
normal operation of the unit will start.