Martin JEM Compact Hazer Pro, Руководство пользователя

Страница: 9 / 30

Quick Start 9
Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot of
haze. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
S e t t i n g u p
Locate the machine in a suitably large area with nothing in front of the haze
output.
Fill the fluid reservoir with JEM C-Plus Haze Fluid only. Use of other fluid will
void the warranty.
Connect a suitably rated power supply to the machine using the supplied mains
cable. The power requirements are:
4.4 A @ 230 V (EU model)
8.68 A @ 120 V (US model)
Now set
the mains switch, at the rear of the machine, to the ‘ON’ position. Select
STBY from the RUN menu. The display will show HEAT , then after about 1
minute the display will show RDY and the machine is ready to produce haze.
M a k i n g h a z e
Press the Menu < > buttons until the display shows RUN , then press the Value
Up/Down buttons to select CONT (continuous). Press Enter.
If there is no haze output or you want to change the haze density, press the
Menu < > buttons until the display shows
HAZE , then press the Enter button and
check that the HAZE setting is above 0%. If not, use the Value up/down buttons
to select a value above 0%.
You can also adjust the fan speed using the
FAN menu.
If no haze is produced it may be necessary to prime the machine,
press the Menu <> buttons until the display shows PRME, then
press the Value Up button so the display shows Y, then press the
Enter button.
S w i t c h i n g o f f
The Compact Hazer is designed to run a self-cleaning cycle before power down
to help prevent blockages. Before disconnecting the power, you should start the
cleaning cycle by pressing the
‘Shutdown Switch’ on the rear of the unit above
the DMX connectors. The red LED in the shutdown switch will light if a cleaning
cycle is needed.
If cleaning is needed, t
he display will show “
WAIT
”, then “
WT44
” counting down
to “
WT00
”. When the display shows “
OFF
” the power may be turned off.
Do not turn off the power without using the Shutdown switch.
This will cause the unit to enter a cleaning cycle when next
switched on, and over time will lead to blockages and
malfunction of the unit.