Martin JEM Compact Hazer Pro, Руководство пользователя

Страница: 14 / 30

14 Control settings
Use the Previous / Next buttons to select the

option.
Use the Up/Down buttons to select

(slave unit) or

(master unit).
Press the Enter button to store the link setting.
The machine should be set to

only if it is running as a master. If running
as a slave, stand-alone or DMX controlled it should be set to

.
A l t o p t i o n
This option is not currently used and has no effect on the machine.
P r i m i n g t h e m a c h i n e a f t e r f l u i d o u t
If the machine runs out of fluid it should be shut down to prevent damage to the
pump. To suck the new fluid back into the machine, replace/refill the fluid
reservoir and use the prime function.
Use the Previous / Next buttons to select the

option.
Use the Up/Down buttons to change the option to

.
Press the Enter button to start the priming function.
The machine will pump at full power for about 10 seconds or until the unit senses
fluid in the heat exchanger.
To exit this menu if you decide not to activate the Prime function, select

and
press Enter.
If the machine is not up to operating temperature the Prime function will do
nothing.
R e s e t t i n g o p t i o n s t o f a c t o r y s e t t i n g s
The factory settings configure a standard mode of operation for the machine.
Use the Previous / Next buttons to select the

option.
Use the Up/Down buttons to change the option to

.
Press the Enter button to reset all options.
To exit this menu if you decide not to reset the options, select

and press
Enter.
The factory settings are:
option setting
HAZE


FAN


TRUN
 
seconds

TOFF
 
seconds

RUN

ADDR 
LINK 
ALT 
PRME 