Martin JEM Compact Hazer Pro, Руководство пользователя

Страница: 10 / 30

10 Installation and setting up
Installation and setting up
DANGER! DO NOT operate the haze machine until you have read and observed
all the precautions listed under “Safety information” on page 4.
L o c a t i o n
The JEM Compact Hazer Pro is designed to be located on the floor or may be
suspended using the optional flying bracket. If suspending the machine, a
hanging bracket (optionally available from Martin) should be attached to the
machine
’s flying bracket with an M12 bolt and nyloc nut.
The machine can operate in any orientation from 30° upwards to 30° downwards.
Steeper tilting may cause fluid leakage.
If the machine is to be suspended, ensure the mounting surface can support the
weight of the machine. Do not suspend the machine over areas where people
will be underneath. Use only the correct Martin flying bracket to suspend the
machine.
Ensure that there is at least 100mm clearance all round the machine and at least
60cm in front of the haze output.
A C p o w e r
Before using the machine, ensure that a grounding-type (earthed) power plug
that fits the local power outlets is installed on the mains power cable provided.
DANGER! Make sure the power plug is correctly rated:
• For EU (230 V) use fit a plug rated 10 A minimum
• For US (120 V) use fit a plug rated 10 A minimum
When installing the plug, follow the plug manufacturer’s instructions and connect
pins as follows:
Yellow and green wire to ground (earth), blue wire to neutral and brown wire to
live.
The table below shows some common pin identification schemes.
wire function marking screw colour
brown live
“L”
yellow or brass
blue neutral
“N”
silver
green/yellow earth green
Before connecting the haze machine to power, verify that the AC supply is
adequately dimensioned for the current draw of the machine. The machine
requires:
4.4 A @ 230 V (EU model)
8.68 A @ 120V (US model)