Martin Professional Wizard Extreme, Руководство пользователя

Страница: 30 / 43

30 Wizard Extreme user manual
3. If replacing a lamp, grasp the old lamp by the
reflector and pull it out of the holder. Then pull
the socket off the lamp. Do not pull the wires.
4. Push the socket fully onto the pins of the new
lamp.
5. Clean the glass bulb with the cloth supplied
with the lamp, particularly if your fingers
touched the glass. A clean, lint-free cloth
wetted with alcohol may also be used.
6. Gently push the lamp into the holder until it
snaps into place.
7. Replace the lamp-access cover and screws.
A d j u s t i n g t h e l a m p
The Wizard Extreme lamp assembly is adjusted at the factory. Due to
differences between lamps, however, fine adjustment may improve
performance.
1. Disconnect the fixture from AC power.
2. If you are:
• Using a controller, turn on the Wizard Extreme and select white
light with the open gobo.
• Not using a controller, flip DIP-switch pins 3 and 10 on. Flip all
other pins off. Apply power to the Wizard Extreme. After it has
reset, the fixture produces a white light with an open gobo for
adjustment purposes.
3. Wait for the lamp to reach full brightness.
4. To reduce the number of images, deflect the light stream away before
it strikes the mirror drum by holding a small hand-held mirror in front of
the it. Lamp adjustment is also easier if you reflect onto a white surface
5. Make adjustments using the
three lamp-adjustments screws:
• If there are off-center “hot
spots” in the images then the
lamp is not centered in the
reflector. Pull the hot spots
into the center of the image
fields with small adjustments
of the lamp-adjustment
thumbscrews.
• If the light is brighter in the center of the images than it is at the
edge, then the lamp is too far forward in the reflector. Pull the lamp