Martin Professional Wizard Extreme, Руководство пользователя, Страница: 24 / 43

24 Wizard Extreme user manual
S E T T I N G T H E D M X M O D E
1. Disconnect the fixture from power.
2. To set the Wizard Extreme to:
• 11-channel DMX mode set DIP-switch pins 10 and 11 to OFF.
• Wizard emulation 8 channel DMX mode reset jumper PL118 on
the circuit board (see “Setting Wizard emulation and 1-channel
modes” on page 31) and set DIP-switch pins 10 and 11 to OFF.
• 1-channel DMX mode reset jumper PL118 on the circuit board
(see “Setting Wizard emulation and 1-channel modes” on page 31)
and set DIP-switch pin 10 to OFF and pin 11 to ON.
D M X C O N T R O L A D D R E S S
The control address, also known as the start channel, is the first channel
used to receive instructions from the controller. Each fixture needs its own
control address set, and uses this address and subsequent control
channels to receive instructions from a controller.
When the Wizard Extreme is in 11-channel mode, it reads the DMX data
on the start channel and the next ten channels. If the DMX control address
is set to 100, the fixture uses channels 100 - 110. Channel 111 is available
for use as the control address for the next fixture.
If the Wizard Extreme is set to Wizard emulation 8-channel mode, it reads
the DMX data on the start channel and the next seven channels.
If the Wizard Extreme is set to 1-channel mode, it reads the DMX data on
the start channel only.
For independent control, a fixture must not use any DMX channel used by
another fixture. If two or more fixtures are set up with the same address,
they will receive the same instructions and should behave identically.
Setting up identical fixtures with the same address is a good tool for
troubleshooting unexpected behavior and an easy way to achieve
synchronized action.
S p e c i f y i n g a D M X a d d r e s s
DIP-switch pins 1-9 are used to set the control address:
1. Select an address for the fixture on your controller. If you are
calculating the DMX addresses for multiple fixtures, save time by using
the Martin Address Calculator at
http://www.martin.dk/service/utilities/AddrCalc/index.asp